To program the Intelli-Cycle simulation click the "Program" button **. Change the options with the "Change" button and "Set" the option with the "Set" button.

The first option is whether the Light Sensor will be active. With the light sensor active you can have different cycles in the light than in the dark. When the simulation is running click the Light Sensor to simulate light or dark conditions and watch the cycles change.

The next series of options will be to set the "On" and "Off" times. To simplify this you set each one in 3 stages, hours, minutes and seconds. Click the "Change" button until the desired time is showing and click the "Set" button to set this entry and move to the next option.

** On the actual Intelli-Cycle there is no "Program" button. You press and hold both "Change" and "Set" buttons for 3 seconds to enter the Program Mode.

*** There is no delayed start option in this simulator.